1-800-876-5520 • gardeners.com
info@gardeners.com
8% of our profits go back to our communities.
Learn more at gardeners.com/FoRCE-FoR-GoOD
PLEASE
RECYCLE
Parts List Tools Needed
() ' x " or () ' x " BOARDS Screw gun or drill with # Phillips bit
() CORNERS Phillips screwdriver
() PLATFORM SUPPORTS Rubber mallet or hammer
() FLAT STOCK Tape Measure
() ' END PANELS Clamp (optional)
() CROSS SUPPORTS
() CORNER CAPS
() SCREWS
FLOOR PLANKS
FABRIC LINER
Assembly is easiest with two people.
Assembly
NOTE: Illustrations show 8" H boards. For video instructions, go to gardeners.com
Boards may have a rough and a smooth side.
1. Align the short edges of two " or four " BOARDS (smooth sides facing down) and clamp or hold them firmly together.
2. Slide a CORNER onto the ends of the BOARDS, positioning it as shown in Figure 1. The top BOARD should come to sit ⅛"
above the top of the CORNER.
3. Making sure there is no gap between BOARDS and that they are fully seated into the CORNER, secure with PHILLIPS SCREWS.
Leave the
nd
hole from the bottom open for now.
4. Repeat Steps - to attach another CORNER to the other end.
5. Take a PLATFORM SUPPORT and place the face with holes against the BOARDS as shown in Figure . Align the holes on
the ends with the holes you left open in Step and secure with PHILLIPS SCREWS.
6. Slide FLAT STOCK underneath the PLATFORM SUPPORT and align holes as shown in Figure 1. Secure the FLAT STOCK with
PHILLIPS SCREWS.
7. Repeat Steps - to assemble the other side panel.
8' BOARDS
(rough faces)
holes
PLATFORM SUPPORT
FLAT STOCK
CORNER
Figure 1
The top BOARD
should sit ⅛"
above the
CORNER.
Instructions for 2' x 8' Elevated Planter Box
S Rev /#,