2
Winch Instruction Page
Safety Information
1. The winch is built for the multipurpose of hauling and lifting operations. It is not to be used
as a hoist for lifting, supporting or transporting people, or for loads over areas where people
could be present.
2. The winch should be operated and maintained in accordance with the instructions. Never
allow children or anyone who is not familiar with the operation of the winch to use it. A winch
accident could result in injury.
3. Check the winch for proper operation on each use. Do not use if damaged and seek
immediate repairs.
4. Never exceed the rated capacity. An excess load could cause failure and may result in injury.
5. Never apply a load on the winch with the cable fully extended. Keep at least three full turns
of cable on the reel.
6. Secure load properly.
Winch Mounting
When mounting the winch to the Vibo lifts, be sure that the winch wheel hub is facing out
away from the lift. Slide the winch on using the easy to use winch slide brackets, as illustrated
further in the instructions.
Assembly
Thread the winch wheel onto the winch drive shaft, be certain that a clicking sound is
produced when the winch wheel is turned clockwise. Install the spring, shaft extension, washer
and bolt on the end of the drive shaft. These parts may appear to serve no function, but they
provide several important fail-safe features and should not be altered or removed.
Operating Instructions
Wind the cable on the winch reel by turning the winch wheel in a clockwise direction. This
should produce a sharp loud clicking sound. The load will remain in position when the winch
wheel is released. Wind cable off the winch reel by turning the winch wheel counter-clockwise
(no noise will be produced). The load will remain in position when the winch wheel is released,
but for extra security it is recommended that the wheel be turned clockwise at least two clicks.
This will add extra tightness to the brake mechanism. Always satisfy yourself that the winch is
holding the load before releasing the winch wheel.