3
2
click
click
click
Fig. 1 Fig. 2 Fig. 3
1. Undress the doll, bend her legs, and place her on the potty in sitting position (Fig. 1).
2. Press and hold the belly button once to make the doll pee (Fig. 2).
3. Press twice and hold to make the doll poo (Fig. 3).
4. Keep the belly button pressed until the doll is completely empty.
NOTE: The belly button will always be blocked if the legs are not bent properly.
1. Fill the plate up to the mark (12 ml) with water.
2. Mix in the food packet until all lumps are stirred in and the water has been fully absorbed.
The mixture will have a thin consistency.
3. Lay BABY born® across your arm and feed her with your other hand using the included spoon.
1. After feeding with water, squeeze the baby’s right arm several times to make her cry.
NOTE: Do not make BABY born® pee into the diaper or potty before crying.
BABY born® can have a bath in the bathtub or be taken to the swimming pool, but do not immerse in water.
• Before bathing, make sure the screw cap on the doll’s back is closed (slot of screw cap is vertical).
• For bathing, only use cold or lukewarm water and only use common bath additives suitable for children.
• The doll should not be left in the bath, chlorine water or salt water for more than 3 hours as color
deterioration or bleaching may occur.
•After bathing, clean the doll with fresh water.
•If water gets into the doll during bathing, an adult can dry BABY born® as follows:
1. Use a screwdriver or coin to unscrew the cap counterclockwise. Then, pull it out.
NOTE: It cannot be completely removed.
2. Carefully shake the doll with its back facing downward. Repeat several times.
3. Vent the doll with the cap open to remove any residual moisture.
4. After drying, close the screw cap clockwise.
Feeding Porridge:
Using the Potty:
Using the Diaper:
Crying:
Bathing and Drying:
Cleaning:
1. After feeding with water lay BABY born® down and she will soil her diaper.
2. Remove her diaper and let it air dry before using again.
It is absolutely necessary to clean the internal tube system immediately after emptying. See CLEANING.
1. If the doll gets dirty, wipe with a damp cloth.
External:
Internal:
1. After feeding and bathing, ll the bottle with warm water and mild dish soap.
2. Insert the tip of the bottle halfway into the baby’s mouth pointing downward and squeeze the bottle.
NOTE: Inserting the bottle too far will clean the wrong internal tubing.
3. Once the bottle is empty, shake the baby to loosen the remnants inside.
4. Place the doll on the potty in sitting position and press and hold the belly button to empty out the doll.
5. Repeat as necessary. Then, rinse out the doll twice with clear water only.
6. Leave the doll on the potty for at least 15 minutes to ensure she is completely empty.
bathtub sold separately